IBM 3745 Connection And Integration Manual page 58

Step
Step
2-10
3745 All Models & 3746-900: CIG
2
Unplugging cable(s)
a. Ask the operator of the appropriate console to log off.
b. Touch the electrostatic discharge plate.
c. Unfasten the cable ground clamp. The cable clamp is fixed at the
bottom left of the frame by one of the three wing nuts.
d. Unplug the cable by squeezing the levers on the top and bottom of
the plug and pulling it out.
If you are going to plug in a new cable, continue with the next step.
Otherwise, go to Step 4 on page 2-11.
3
Plugging in cable(s)
a. Refer to the figures of the Step 2.
b. Locate the cable by the label on the cable.
c. Touch the electrostatic discharge plate.
d. Plug in the console cable.
e. Fasten the cable ground to the frame with the cable clamp. The
cable clamp is fixed at the bottom left of the frame by one of the
three wing nuts.
Note: The cable clamp serves to reduce the possibility of radio
frequency interference that might be caused by the operating
machine. Proper installation of the cable clamp is necessary to
meet FCC requirements and to conduct electrostatic discharges to
ground.
RSF REMOTE LOCAL