Integrating an Initial Installation
When the service representative asks you, perform the following required
procedures:
1. "Upgrade Procedure" on page 5-8
2. "Updating Link IPL Ports" on page 5-17 if you have a link-attached 3745
3. "Saving MOSS from Fixed Disk onto Diskettes" on page 5-19. This procedure
You may perform the following optional procedures anytime before "Saving MOSS
from Fixed Disk onto Diskettes":
1. "Changing Passwords on the 3745 MOSS" on page 5-14
2. "Setting Power On Schedule" on page 5-16.
Perform "Putting the MOSS On-Line" on page 5-21 whenever needed.
Notes:
1. The integration procedure (LIC types 1-4) must be performed in disk mode
2. If you want to change the operating mode of a 3745 Model 410 or 610 (twin
Integrating a Later Modification
Perform the appropriate procedures in the rest of this chapter that apply to your
3745 installation. After you have completed your modification, perform a backup of
the 3745 fixed disk. See "Saving MOSS from Fixed Disk onto Diskettes" on
page 5-19.
Note:
Conventions Used in this Chapter for the MOSS
Symbols for the Keys: When you see a keyboard symbol, press and release the
corresponding key. For example,
and release the C key, the S key, the R key, and then the Enter key in, that order.
Messages Displayed: They are shown like this:
5-6
3745 All Models & 3746-900: CIG
is performed after all other required and optional procedures.
because it uses MOSS functions, which are not available in diskette mode.
CCUs) refer to the CDF-CCU operating mode function in the Advanced
Operations Guide, SA33-0097. Perform the appropriate procedure before
saving the fixed disk onto diskettes.
When reconfiguring LICs, ensure that the total weight of lines connected to a
low-speed scanner is within the scanner capacity.
To calculate them see Appendix A, "LSS Characteristics and Line Weights."
CDF UPGRADE COMPLETED
means you must press