IBM 3745 Connection And Integration Manual page 126

Step
Step
Step
Step 10
Step 11
Step 12
Step 13
Step 14
Step 15
Step 16
Step 17
Step 18
5-20
3745 All Models & 3746-900: CIG
7
8
When this message is displayed:
MOSS-OFFLINE
continue with the next step.
9
To copy your disk onto diskettes, you need five or six PC diskettes. You
can either use the set of backup diskettes located in the diskette holder
on the left of the 3745 control panel, or use new diskettes.
If you use new diskettes, they should be part number 2HC 6009649 or
equivalent double-sided, high-capacity, 5.25-inch diskettes.
Your diskettes must be formatted. The set of backup diskettes that
came with the 3745 are already formatted. If the new diskettes are not
formatted, format them using the diskette initialization function:
See the Advanced Operations Guide, SA33-0097.
Otherwise, continue with the next step.
Enter the diskette identification. Use from one to eight alphanumeric
characters. You may use blanks. Then:
Insert PRIMARY diskette. When it is in place:
When you see the following message:
DISK SAVE ONTO PRIMARY DISKETTE COMPLETED
REMOVE DISKETTE THEN PRESS SEND
remove the diskette, then:
Repeat Steps 14 and 15 for the secondary, third, fourth, and fifth
diskettes when prompted.
Note: For Models A, there is a sixth diskette.
Note the information about the date, engineering change (EC), and the
IDs on each diskette, then:
You have finished this procedure. If you want to put the MOSS on-line,
then:
If the MOSS is off-line, then go to "Putting the MOSS On-Line" on
page 5-21.
If the MOSS is alone, then go to "IPL and Loading the Network
Control Program" on page 5-18.
Otherwise, this is the last procedure done.