IBM 3745 Connection And Integration Manual page 33

Step
Step
Unplugging or Plugging In a Token-Ring Adapter (TRA) Cable
Step
Magnetic Cable Clamp
5
Activating the lines
Ask the host operator to activate any lines plugged in.
Notes:
a. The line number is the same as the port number.
b. If you have installed a link-attached 3745, make sure that the link
IPL port cables are connected before attempting an IPL.
6
You have finished this procedure
Close and lock the door using the special door key.
If you have a 3745 Model A without a 3746-900 attached
Do not use this procedure to make changes to the cable that connects the 3745
to the token-ring LAN used by the service processor. These are IBM service
representative tasks.
1
Starting
If you have not done the procedure "Getting Started" on page 1-2, do
so now.
If you are only plugging in TRA cable, go to Step 3 on page 1-12
Otherwise, continue with the next step.
Chapter 1. 3745 Models 210 to 61A: Connecting LICs and Cables
Extra Clamps are Available on Request.
Please Contact your IBM Service Representative.
The Part Number is 26F1775.
1-11