Part 2. Integrating - IBM 3745 Connection And Integration Manual

This part explains the procedures used to integrate hardware and software
configuration changes into your network. It contains two chapters:
 Copyright IBM Corp. 1988, 2003
Chapter 4, "Starting the 3745 Integration," guides you through the following
chapters according to your present task.
Chapter 5, "Integration Procedures":
– Has an introduction to MOSS-E use for integrating changes in the:
- MOSS
- MOSS-E
- service processor
- and 3746-900.
Some of these are:
- Changing the MOSS-E and DCAF passwords
- Verifying that the hardware (LIC types 11, 12, and 16, LCBs, and
ARCs) changes have been recognized by the MOSS-E
- Modifying and saving the configuration data file - extended (CDF-E).
– Gives the procedures for using the MOSS functions for integrating changes
in the 3745 base frame. Some of these are:
- Changing passwords, if you do not have a Model A
- Modifying the configuration data file (CDF)
- Backing up the MOSS hard disk.
Note: Before using the procedures in Chapter 5, the 3745 (and 3746-900, if
you have one) must be powered ON.

Part 2. Integrating