Table of Contents
Advertisement
4-9.
DC Fan (40 Square)
Preparation
1.
Remove the inside panel assembly. (Refer to
2.
Remove the DPR assembly. (Refer to
Procedure
1.
Disconnect the harness from the connector (CN020) on the AU-374 board.
2.
Remove the two screws, and remove the fan bracket.
3.
Remove the fan cushion and DC fan (40 square) from the fan bracket.
Harness
CN020
AU-374 board
Note
When installing the DC fan (40 square), pay attention the position of the label and the harness.
4.
Install the removed parts by reversing the steps of removal.
HXC-FB75H/HXC-FB75KC
"4-4-1. Inside Panel
Assembly")
"4-6. DPR
Assembly")
Label
DC fan (40 square)
Harness
Fan cushion
Fan bracket
PSW3 x 8
4-27
Advertisement
Table of Contents
