Table of Contents
Advertisement
Replacement DPR-373 Board
1.
Upgrade the PLD data.
(Refer to
"7-2.
PLD".)
4-3-4.
Alignment and Setting Required when Replacing SY-451 Board
Camera setting status and files are stored in the SY-451 board. When the SY-451 board is replaced, contents of the
reference file, scene file, lens file, and operator file are lost. Store these files in a USB drive and then replace the SY-451
board.
The content of the OHB file stored in the prism block assembly is not lost.
Procedure
1.
Store the operator file, scene file, and reference file in a USB drive.
• Operator file (Refer to
• Scene file (Refer to
• Reference file (Refer to
2.
Replace the SY-451 board.
(Refer to
"4-4-3. SY-451
3.
Upgrade the PLD data.
(Refer to
"7-2.
PLD".)
4.
Execute REFERENCE (ALL) on the FILE CLEAR page of the FILE menu.
(Refer to
"8-5. Reference
5.
Execute STORE FILE on the REFERENCE page of the FILE menu.
(Refer to
"8-5. Reference
6.
Execute the automatic adjustment.
(Refer to
"6-2. Automatic
7.
Load the operator file, scene file, and reference file stored in the USB drive in step 1.
• Operator file (Refer to
• Scene file (Refer to
• Reference file (Refer to
8.
Readjust the lens and OHB.
(Refer to
"8-6. Lens
File",
9.
Set the model name and serial number again on SERIAL NO. page of the SERVICE menu, and execute the STORE
FILE.
(Refer to
9-2-1."SERIAL
4-3-5.
Alignment and Setting Required when Replacing AT-189M Board
AT-189M board stores the software programs of camera and the model information data.
Note
If attach the AT-189 board other than the AT-189M board used in this unit, the unit does not work properly.
Procedure
1.
Replace the AT-189M board.
(Refer to
"4-4-2. AT-189M
2.
Upgrade the software.
(Refer to
"7-1. Upgrading Software
HXC-FB75H/HXC-FB75KC
"8-2. Operator
File".)
"8-4. Scene
File".)
"8-5. Reference
File".)
Board".)
File".)
File".)
Adjustment".)
"8-2. Operator
File".)
"8-4. Scene
File".)
"8-5. Reference
File".)
"8-7. OHB
File".)
NO.".)
Board".)
Programs".)
4-5
Advertisement
Table of Contents
