Sony HXC-FB75H Service Manual page 100

7. Install the DPR assembly. (Refer to
Note
Connect the optical cables according to step 8.
8. Pass the two optical cables into the clamper and connect them as shown below.
Note
• Before connecting the optical fiber cable, clean its end.
• Connect optical cables correctly according to respective marks ("1" and "2") .
• Pass the optical cables at the DPR board side of the IF-1306 board.
• Do not bend the optical cables strongly.
Optical module
Optical cables
[1]
[2]
9. Install the inside panel assembly. (Refer to
HXC-FB75H/HXC-FB75KC
"4-6. DPR Assembly")
Clamper
IF-1306 board
"4-4-1. Inside Panel Assembly")
5-4