Precaution On Replacing The Sy-327 Board; Addition Of Destination Data File - Sony DSC-WX150 Service Manual

1-1. PRECAUTION ON REPLACING THE SY-327 BOARD

DESTINATION DATA
When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Start the Adjust Manual in the Adjust Station and execute the "DESTINATION DATA WRITE".
RESTORE DATA
When you replace to the repairing board, get the data from the former one.
Start the Adjust Manual in the Adjust Station and perform "RESTORE DATA" to get the data.
The data getting for this model is as follows.
• USB SERIAL No.
• Angular Velocity Sensor Sensitivity adjustment
• AWB standard data input & check, Color reproduction check
Regarding the PlayMemories Home
PlayMemories Home has been written in internal memory.
SY-327 board for service is supplied with written the PlayMemories Home.
USB SERIAL No.
The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Start the Adjust Manual in the Adjust Station and execute the "USB SERIAL No. INPUT".
Angular Velocity Sensor
When you replace to the repairing board, write down the sensitivity displayed on the angular velocity sensor (SE401).
Start the Adjust Manual in the Adjust Station and execute the "Angular velocity sensor sensitivity adj".
SY-327 BOARD (SIDE A)
SE401
Type A:
P
Y: YAW sensor sensitivity
Type B:
P: PITCH sensor sensitivity
Note: The sensor sensitivity of SE401 of SY-327 board is written only repair parts.
DSC-WX150_L2
Y
1. SERVICE NOTE

1-2. ADDITION OF DESTINATION DATA FILE

If the Destination Data file included in the Adjust manual is old, "DESTINATION DATA WRITE" cannot be executed in some cases.
In that case, download a new Destination Data file from the TISS homepage according to the following procedure.
Note 1: To perform Destination Data Write for this model, the Adjust manual of the DSC-WX50 series must have been installed.
Install the Adjust manual of the DSC-WX50 series in advance.
Note 2: The actual image may differ from the image shown above.
1) If the Destination Data file in the Adjust manual in use is old, the window shown in Fig. 1 is displayed.
Click the [OK] button.
2) The Destination Data Write window opens.
Check the version of the Destination Data file retained in the Adjust manual.
1-1
Fig. 1
Destination Ver. window