Cayman Systems 2E-H-W User Manual page 98

Using the Command Line Interface
4-40
set snmp community name
Adds the specified name to the list of communities associated with
the Cayman 2E-H-W. By default, the Cayman 2E-H-W is associated
with the public community. You can associate as many as 16
communities with the Cayman 2E-H-W.
set snmp traps authentication-traps { on | off }
Enables or disables SNMP trapping. If SNMP trapping is enabled,
your Cayman 2E-H-W sends authentication traps to all SNMP trap
destinations. You must enable trap authentication before you set up
your trap destinations.
set snmp traps ip-traps ip-address [ community
community-name ]
Identifies the destination for SNMP trap messages. The
argument is the IP address of the host acting as an SNMP console.
The optional
community community-name
Cayman 2E-H-W community, which is included in the trap message
the device sends to the management console. This name, which is
not used for authentication, does not have to match a predefined
community name.
set snmp sysgroup contact contact_info
Identifies the system contact, such as the name, phone number,
beeper number, or email address of the person responsible for the
Cayman 2E-H-W. You can enter up to 256 characters for the
argument. You must put the
contact_info
in double-quotes if it contains embedded spaces.
set snmp sysgroup location location_info
Identifies the location, such as the building, floor, or room number,
of the Cayman 2E-H-W. You can enter up to 256 characters for the
argument. You must put the
location_info
argument in double-quotes if it contains embedded spaces.
ip-address
identifies the name of the
contact_info
location_info
Cayman 2E-H-W User's Guide
November 2000
argument