About Config Commands; Config Mode Prompt - Cayman Systems 2E-H-W User Manual

About CONFIG
Commands
CONFIG Mode
Prompt
Using the Command Line Interface
4-14
who
Displays the names of the current shell users.
wireless learn
Lets you put your Cayman 2E-H-W into Learn mode for 60 seconds,
allowing it to acquire its network address from a HomeRF device in
Teach mode on your network. Only supported for HomeRF.
wireless teach
Lets you put your Cayman 2E-H-W into Teach mode for 60 seconds,
allowing it to advertise its network address to other HomeRF devices
in Learn mode on your network. Only supported for HomeRF.
You reach the configuration mode of the command line interface by
typing (or any truncation of
configure
) at the CLI ROOT prompt.
config
When you are in CONFIG mode, the CLI prompt consists of the
name of the Cayman 2E-H-W followed by your current node in the
hierarchy and two right angle brackets (>>). For example, when you
enter CONFIG mode (by typing
prompt reminds you that you are at the top of the
Dogzilla (top)>>
CONFIG hierarchy. If you move to the
hierarchy (by typing
to
Dogzilla (ip)>>
Some CLI commands are not available until certain conditions are
met. For example, you must enable IP for an interface before you can
enter IP settings for that interface.
configure
at the ROOT prompt), the
config
ip
at the CONFIG prompt), the prompt changes
ip
to identify your current location.
Cayman 2E-H-W User's Guide
, such as or
c
node in the CONFIG
November 2000