Cayman Systems 2E-H-W User Manual page 136

Diagnostic Console
B-8
sequence tries to load an image from download sources in the
following order:
1. If flash is enabled, start an image from the Cayman 2E-H-W code
flash memory, using the configured image number; else
2. If ip is enabled, load an image via IP TFTP using the configured
IP server, IP gateway, netmask and filename; else
3. If bootp is enabled, load an image from a BOOTP server on your
IP network.
The Cayman 2E-H-W alternates steps 2 and 3 at 10-second intervals
for the number of attempts specified in the
trying each download source that is enabled.
bootp { on | off }
The command enables/disables BOOTP downloading. If
bootp
BOOTP is enabled, the Cayman 2E-H-W broadcasts a BOOTP request.
It will use the response as the source of its IP address, the server and
gateway IP addresses, and the name of the file to TFTP-download.
The EPROM recognizes the CMU and RFC-1048 "vendor extensions"
to the basic BOOTP format, and uses the netmask and gateway
address provided by BOOTP if available.
file file_name
The command specifies the name of the EPROM software file
file
the Cayman 2E-H-W should download.
flash { on | off }
The command enables/disables flash booting. If the specified
flash
boot image in flash memory is valid, it will be used as the source of
the image to run when the box autoboots or when the command
boot flash is given.
enables downloading from flash.
flash on
retry_count
Cayman 2E-H-W User's Guide
November 2000
argument,