Xilinx Spartan-3A DSP S3D1800A Getting Started page 13

R
3.
4.
If the configuration in the FLASH is inadvertenly erased, download the initial bit streams
and MEM files from http://www.xilinx.com/s3adspmb.
Getting Started SP-3A DSP S3D1800A
UG485 (v1.0) January 28, 2008
When this initial test has completed, press any key to continue with additional options.
The following text will appear.
=============================================================
/ /\/
\ \
/ /
\_\/\
=============================================================
Type <help> for options
>
Type help to view the addtional options listed below.
Menu:
cls
b
fce
flash
fbe <start> <end>
fac <start> <end>
ddr
mem <start> <end>
mrd <start> <end>
mwr <addr> <data>
gpio
q
exp
for connectivity.
test
help
>
www.xilinx.com
Xilinx Spartan3A DSP 1800A
Hello World and Board Bringup Test
clear screen
display banner
Flash Chip Erase
Flash Test
Flash Block Erase
Flash Address Check
DDR2 SDRAM Test
Test mem region
Dump mem region
Write mem location
GPIO Test
quit (exit to xmd)
Use Loopback cable. Drive JX1 & read JX2
Perform factory tests
View this menu
Step 3
11