Lcd Display References - Viking H-10 Installation Instructions And Safety Information

TROUBLESHOOTING

LCD Display References

The Control Board is equipped with a LCD Display that provides operator information,
current conditions, settings, diagnostics and error messages. Use the table below
to identify the corresponding "TS Ref#" and refer to pages 34-40 for further
troubleshooting.
Meaning
LCD MSG
MODEL
Indicates the Model of the unit
H-10 SPS
System Status Messages
GATE IS
Gate is stopped between limits
IDLE
GATE IS
Gate is opening
OPENING
GATE IS
Gate is closing
CLOSING
GATE IS
Gate is at the limit open position
OPENED
GATE IS
Gate is at the limit close position
CLOSED
STOP BY
Gate has stopped due to an obstruction of the gate system. Also refer to the
"ODS" LED. (pg 22, 24, 34)
OBSTRUCT
STOP BY
Gate has stopped due to an overload of the gate system. Also refer to the
"ODS" LED. (pg 22, 24, 34)
OVERLOAD
HOLDING
Gate is at the limit open position and timing to close - The display shows the
actual time left before closing
__ SEC
Indicates the number of connected Monitored Entrapment Protection Sensors
UL LEARN
that are being monitored.
UL_ RO_
3 6
1. Error Messages will be displayed first.
2. The "Diagnose" LED will flash consecutively
indicating how many Error Messages are
available.
3. Press the Diagnose button to manually
scroll through all of the Messages.
NO LEARN
= no sensors learned. (pg 6-7, 18)
VIKING TECHNICAL SUPPORT 1.800.908.0884
Page 40
TS Ref #s
11, 12, 13
11, 12