Monitored Entrapment Protection Installation; Manual Release - Viking H-10 Installation Instructions And Safety Information

!
WARNING! Not Following these instructions may cause severe injury or death.

Monitored Entrapment Protection Installation

! IMPORTANT:
A minimum of two Monitored External Entrapment Sensors are required to be
connected as follows: One to the UL terminal and one connected to the Re-Open terminal,
OR two sensors connected to the UL terminal, one for EACH DIRECTION of travel.
"UL"
Protects against entrapment in both the opening and closing directions. Input will
reverse the gate momentarily in the opposite direction it was traveling. Refer to page 18.
"Re-Open"
Protects against entrapment in the closing direction ONLY. Input will reverse the
gate all the way to the Open Limit. Refer to page 18.
STEP 1:
Connect the monitored entrapment
protection sensor(s) to the Viking Control
Board.
Refer to page 22 for detail

Manual Release

When manual operation is required:
1. Lift the Access Door, located on the front of the cover.
2. Press the Manual Release Switch to the "RELEASE"
Position.
The gate can now be moved manually.
To resume normal operation, press the switch to the
"ENGAGE" position.
VIKING TECHNICAL SUPPORT 1.800.908.0884
IMPORTANT SAFETY INFORMATION
10K Monitored Terminal
10K Monitored Terminal
UL SENSOR ERRORS:
If a problem occurs with one of the monitored
UL LEARN
entrapment sensors, the "Stop" LED will illuminate
NO LEARN
and an ERR message will be displayed, indicating
which input terminal(s) the sensor is connected to.
TERMINAL:
STEP 2:
Execute the Learn Process:
• Press and release the "Diagnose" button
until you see
LCD Display.
• Press and hold the "Stop" button.
• Toggle the "Diagnose" button once.
• The number of Monitored sensors
connected to the "UL" or "Re-Open"
terminals will now be displayed.
EXAMPLE:
"UL"
ERR SENS
ERROR
MESSAGE:
UL
UL LEARN NO LEARN
UL LEARN
UL2 RO1
"Re-Open" "UL" & "Re-Open"
ERR SENS ERR SENS
RO UL
RELEASE ENGAGE
on the
RO
RESET
7