Lcd Display References - Viking I-770 Installation Instructions And Safety Information

Single and dual gate systems

Hide thumbs

Table Of Contents

Table of Contents

TROUBLESHOOTING

The Control Board is equipped with a LCD Display that provides operator information,

current conditions, settings, diagnostics and error messages. Use the table below to

identify the corresponding "TS Ref#". Refer to pages 36-41 for further troubleshooting.

Meaning

LCD MSG

MODEL

Indicates the Model of the unit. I-770

i770

System Status Messages

GATE IS

Gate is stopped between limits.

IDLE

GATE IS

Gate is opening.

OPENING

GATE IS

Gate is closing.

CLOSING

GATE IS

Gate is at the limit open position.

OPENED

GATE IS

Gate is at the limit close position.

CLOSED

STOP BY

Primary or Single motor has stopped due to an obstruction of the gate system.

Also refer to the "ODS" LED. (pg 24, 26, 36 @ #4, 37 @ #18)

OBSTRUCT

STOP BY

Primary or Single motor has stopped due to an overload of the gate system.

Also refer to the "ODS" LED. (pg 24, 26, 36 @ #4, 37 @ #18)

OVERLOAD

OVERLAP

Gate is waiting for the overlap time.

TIMING

HOLDING

Gate is at the limit open position and timing to close - The display shows the

actual time left before closing.

__ SEC

STOP BY

Secondary motor has stopped due to an obstruction sensor event. Also refer to

the "DIAGNOSE" LED on the Secondary Module. (pg 24, 26, 36 @ #4, 37 @ #S1)

ODS

RED CONN

The Motor Connector is not plugged into the red Open Left or Open Right

socket at the Control Board. (pg 11, 20)

UNPLUGED

3 8