Control Board Setup - Viking H-10 Installation Instructions And Safety Information

CONTROL BOARD SETUP

Initial Settings
"Speed"
Motor Speed
Increases or decreases the speed of gate
travel.
"Overlap"
Overlap Delay
!
This Feature is disabled on Slide Gate
models.
2 2
"ODS"
Obstruction Detection Sensor
Sets the amount of force required to trip
the inherent obstruction sensor.
See page 24 for more details about this
feature.
"Timer"
Hold Open Timer
Automatically closes the gate after
the selected amount of time from 1-60
seconds.
Turning the dial between "0" and "OFF"
will disable this feature, requiring a close
command to close the gate.
VIKING TECHNICAL SUPPORT 1.800.908.0884