Related Manuals for Keysight Technologies E4461B
Summary of Contents for Keysight Technologies E4461B
- Page 1 Keysight E4461B E4462B E4463B Front Door Kit for E7590A 1.3 Meter Instrument Rack E3661B 1.6 Meter Instrument Rack E3662B 2.0 Meter Instrument Rack Assembly Instructions...
- Page 2 WITHOUT NOTICE, IN FUTURE EDI- without prior agreement and written con- ment of Defense FAR Supplement TIONS. FURTHER, TO THE MAXIMUM sent from Keysight Technologies, Inc. as (“DFARS”) 227.7202, the U.S. govern- EXTENT PERMITTED BY APPLICABLE governed by United States and interna-...
- Page 3 Safety Information Do Not Remove Instrument Cover The following general safety precau- tions must be observed during all Only qualified, service-trained person- phases of operation of this instrument. nel who are aware of the hazards Failure to comply with these precau- involved should remove instrument tions or with specific warnings or oper- covers.
- Page 4 Safety Symbols A CAUTION denotes a hazard. It calls attention to an operating The CSA mark is a registered trade- pro-cedure or practice, that, if not mark of the Canadian Standards Asso- cor-rectly performed or adhered South Korean Class A EMC Declara- ciation and indicates compliance to to could result in damage to the tion.
-
Page 5: Table Of Contents
Contents Contents ........................6 General Information ....................6 Tools Needed ......................6 Installation Procedure ....................7 Preparing the Front Door Assembly ................ 7 Attaching the Front Door to the Rack ..............9 Keysight E4461B E4462B E4463B Front Door Kit Assembly... -
Page 6: Contents
2.0 Meter Front Door Kit E3662 Tools Needed • M3 wrench or crescent wrench for M3 nut • M4 wrench or crescent wrench for M4 nut or 10-32x0.5” nut • Torx T25 screwdriver Keysight E4461B E4462B E4463B Front Door Kit Assembly... -
Page 7: Installation Procedure
3. Attach the remaining part of the hinge assembly to the hinge brackets. Do not over tighten the nuts. 4. Attach the latch to the front door assembly. Insert the bolt through the latch bracket and into the latch itself, as shown in Figure 1. Keysight E4461B E4462B E4463B Front Door Kit Assembly... - Page 8 Figure 1. Front Door Kit Figure 2. Hinge Assembly Keysight E4461B E4462B E4463B Front Door Kit Assembly...
-
Page 9: Attaching The Front Door To The Rack
7. Attach the latch catch bracket to the right front column using the 10-32 screws and nuts. 8. Reinstall both of the side panels. Figure 3. Column This completes the installation of the Front Door Kit. Place this Installation Instruction with your rack documentation. Keysight E4461B E4462B E4463B Front Door Kit Assembly... - Page 10 This information is subject to change without notice © Keysight Technologies 2015 Printed in Malaysia Edition 3 August 2015 5967-9321 http://www.keysight.com...
Need help?
Do you have a question about the E4461B and is the answer not in the manual?
Questions and answers