IKEA HJALTEBY Manual page 13

en
WARNING
Do not line the oven walls, racks, bottom or any
other parts of the range with aluminum foil. Doing
so will alter heat distribution, produce poor baking
results and may cause permanent damage to the
oven interior. During self-clean temperatures the
oven will be hot enough to melt foil.
Removing and Replacing the Glide
Racks
The fully extendable Glide rack makes food prepara-
tion easier. This oven rack has glide tracks that al-
low the rack to be pulled away from the oven with-
out rubbing the sides of the oven wall.
To remove - Make sure the baking rack is in the
closed position. Using one hand, reach through
handle opening and grasp both the upper and lower
bars of the glide rack.
While holding both sections, pull the glide rack out
of the oven until the stop position is reached.
BEFORE SETTING OVEN CONTROLS
Using both hands, lift up the front of the rack slight-
ly and continue to pull the rack away from the oven.
Be sure to grasp both upper and lower rack portions
together when removing or handling the glide rack.
The rack portions move independently and are dif-
ficult to handle unless held together.
To replace - Make sure the baking rack is in the
closed position. Grasp both upper and lower por-
tions of glide rack. Lift and hold the rack level
between the oven cavity walls. Tilt the front of the
rack upward slightly and slide the rack completely
into position.
To prevent possible damage to the oven, do not at-
tempt to close the oven door until all the oven racks
are fully positioned back inside the oven cavity.
IMPORTANT
Remove all oven racks and clean according to in-
structions provided in the Care & Cleaning section
of this manual. Never pick up hot oven racks or
parts.
13