IKEA HJALTEBY Manual page 43

en
Aluminum Foil, Aluminum Utensils, and
Oven Liners
WARNING
Never cover any slots, holes, or passages in the
oven bottom or cover an entire oven rack with
materials such as aluminum foil. Doing so blocks
air flow through the oven and may cause carbon
monoxide poisoning. Aluminum foil linings may
trap heat, causing a fire hazard.
• Protective liners—Do not use aluminum foil to
line the oven bottom. The high heat of the oven
can melt these materials to the oven cavity and
ruin the oven. These types of materials can also
reduce the effectiveness of the air circulation
in the oven and produce poor baking results.
Only use aluminum foil as recommended in this
manual. Improper installation of these liners
may result in risk of electric shock or fire.
• Aluminum utensils - The melting point of alu-
minum is much lower than that of other met-
als. Care must be taken when aluminum pots or
pans are used.
• Oven racks - Do not use aluminum foil to cover
the oven racks. Using a liner in the oven re-
stricts the heat and air flow needed to obtain the
best possible cooking results for any oven.
CARE AND CLEANING
Replacing the Oven Light
CAUTION
Be sure the oven is unplugged and all parts are
cool before replacing the oven light.
The interior oven light is located at the rear of the
oven cavity and is covered by a glass shield. The
glass shield must be in place whenever the oven is
in use.
To replace the oven interior light bulb:
1. Turn electrical power off at the main source or
unplug the appliance.
2. Remove interior oven light shield by turning a
quarter turn counter-clockwise.
3. Replace bulb with a new T-4 type Halogen 25
watt appliance bulb.
CAUTION
Be sure the oven is unplugged and all parts are
cool before replacing the oven light.
4. Replace glass oven light shield by rotating clock-
wise.
5. Turn power back on again at the main source (or
plug the appliance back in).
6. Be sure to reset the time of day on the clock.
Figure 11: Wall oven Halogen light
43