Unimog U500 Mounting Manuallines page 88

Body and Implement Mounting Guidelines U500 North America
Removal of the front mounting plate
For vehicles without mounting plate (code D12) a tubular cross
member is fitted between the two halves of the integrated implement
support at the factory. In case, that the front mounting plate has
been removed on vehicles with code D12 the tubular cross member
(part-no.: A 405 520 00 48) has to be retrofitted.
Figure 4.25: Integrated implement support with cross member (MB
part-no. A405 520 00 48)
Note: Loosen the bolt at the steering gearbox and retorque!
August 2005
A 405 520 0048
For retrofitting the tubular cross member, the following parts are
necessary:
Part Number
A 405 525 00 17
A 405 520 37 41
A 405 520 42 41
A 000 987 07 72
A 405 520 00 48
N 910105 020010
N 913023 020001
N 910105 020025
A 405 997 01 01
A 405 520 10 70
A 003 997 39 48
A 405 524 13 40
N 910105 010009
Table 4.9: Parts list for removing the front mounting plate
For further information about removing the front mounting plate and
retrofitting of the cross member please see the Unimog Service Bul-
letin No. 31-2 or contact the Unimog Implement Manager listed at
the beginning of this guideline.
Implement / Body Installation
Description Quantity
Screen 1
Right Bracket 1
Left Bracket 1
Edge Guard 1
Cross-member 1
Right Side Bolts 3
Right Side Nuts 3
Left Side Bolt 1
Bumper Plugs 2
Bumper 1
Bumper Seal Ring 1
Bumper Bracket 1
Bumper Bolts 2
Page 91 of
294