Table of Contents
Advertisement
Body and Implement Mounting Guidelines U500 North America
4.14.6.2
Code D62: (Code D70 included)
The heavy implement mounting supports (code D62, see Figure
4.104, page 147) fit to the serial hole pattern for implement brack-
ets on the chassis frame. These supports should be used for
heavy implements (e.g. backhoes, cranes, all implements which
can raise the vehicle, etc.) and also in cases of multiple applica-
tions, which need both the implement brackets hole pattern (e.g.
front end loaders with an under carriage load bar and a crane with
mounting frame, etc.).
Note: Combination of ex factory mounted platform sub
frames code P60 and heavy mounting brackets (code
D62) is not possible because of collision with welded
consoles on the sub frames.
Note: Retrofitting of the heavy mounting brackets (code D62)
For retrofitting of the heavy mounting brackets the following parts
will be needed:
•
One bolt M14 x 1.5 x 50 mm (part no.: N910 105 014 011)
•
One nut M14 x 1.5
•
Two bolts M12 x 1.5 x 50 mm (part no.: N910 105 012 021)
•
Two nuts M12 x 1.5
Warning:
Risk of vehicle damage!
Fastening of mounting frames using U-bolts and
other clamping devices is not permitted!
Use of wood sills between implement mounting
frame and upper frame flanges is not permitted!
Page 144 of
294
(part no.: N913 023 014 003)
(part no.: N913 023 012 002)
Proposal for an implement mounting support using D62:
The implement mounting frame can be fastened using the heavy
mounting brackets (code D62) like shown in Figure 4.105, page
148. This mounting support can pass high forces through the
bushing (diameter 1.77 in / 45 mm) into the chassis frame. The
projecting end of the mounting bracket above the vehicle frame
provides lateral guidance of the implement-mounting frame. Using
one M24x300 mm bolt (alternative one bolt with diameter of 1 in
and 12 in length, grade 8) in combination with a spacer (Length:
4 in; inner diameter: 1.1 in; outer diameter 2 in) ensures secure
mounting of the implement-mounting frame. The length of the bolts
and spacers depends on the dimensions of the mounting frame.
The bolts should be fastened with a torque of 260 lb⋅ft / 350 Nm.
Implement / Body Installation
August 2005
Advertisement
Table of Contents
