Table of Contents
Advertisement
Body and Implement Mounting Guidelines U500 North America
4.14.8.1
Code D60:
The implement mounting supports (code D60, see Figure 4.147,
page 165) are available for the frame hole pattern shown in Figure
4.103, page 146. On vehicles with short wheelbase there are four
D60 hole pattern and on the long wheelbase are six D60 hole pat-
tern bored.
Examples for the use of code D60 and code D62:
Code D60
• Under carriage load bar by
use of front end loaders
• Cleaning devices between
the axles
• Grader between the axles
Table 4.17: Examples for using codes D60 and D62
•
Bracket D62 is not mountable in combination with the plat-
form subframe code P60 and can therefore not be used in
combination with platforms (code P27 or P40).
•
Bracket D60 must be used when using subframe P60 in
combination with implements mounted between the axles,
such as suction sweepers or undercarriage load bars of
front end loaders (see Figure 4.145 and Figure 4.146).
•
Bracket D60 can also be used for combination of platform
subframes (code P60) and
o Protection bars (mowers)
o Side protectors (snow cutter / blower)
o Implement supports (suction sweepers, etc.)
Page 164 of
294
Code D62
• Cranes
• Aerial devices (man lifts)
• Drillings
(All implements, which can
raise the vehicle)
Figure 4.145: Example for use of code D60
Figure 4.146: Example for use of code D62
Implement / Body Installation
August 2005
Advertisement
Table of Contents
