Table of Contents
Advertisement
Body and Implement Mounting Guidelines U500 North America
Standard bolt holes are located under the floor mat for mount-
ing implement control console supports. We recommend the
use of these for fitting of control consoles in the cab.
A support can be fitted to four threaded holes in the gearshift
console with a weight of up to 6.61 lbs / 3 kg. There are two
M6 thread holes on the sides and two M8 thread holes on top
of the gearshift console.
Control consoles that weigh more than 6.61 lbs / 3 kg must be
attached with three additional securing points under the flood
mat of the cab. For more information and dimensions see
Figure 9.30, page 263 and the following pages.
Figure 9.30: Fastening points for mounting control consoles
August 2005
4 fastening points
on the gearshift
console for light-
weight control
panels
3 additional fas-
tening points for
heavy control
panels
Important Note:
Pay attention to sufficient clearance be-
tween the center console (switch panel)
and the VarioPilot (changeable steer-
ing).
The clearance must be checked after the installation of sup-
port bails and the implement control console to the gearshift
panel (see Figure 9.31).
Figure 9.31: Clearance between steering and gearshift con-
sole
Cab
Page 263 of
294
Advertisement
Table of Contents
