Cable Passage Into The Cab; Cable Passage Through The Rear Wall Of The Cab; Cable Passage Through The Front Wall Of The Cab - Unimog U500 Mounting Manuallines

Body and Implement Mounting Guidelines U500 North America

9.3 Cable passage into the cab

There are two ways to facilitate cable passage into the cab:
•

Cable passage through the rear wall of the cab

•

Cable passage through the front wall of the cab

In the rear wall and also in the front wall of the cab are holes
for cable passages into the cab. The cable passages are
closed with seal caps (part-no. A405 583 00 83, see Figure
9.6). The seal caps can be cut in for cable passages into the
cab.
9.3.1 Cable passage through the rear wall of the cab
The cable passage in the rear wall of the cab is provided in the
area behind the driver seat near the power outlet (see Figure
9.4). Since the Unimog cab can be tilted, plug-connections
must be provided for the cables so the lines are not damaged
when the cab is tilted.
9.3.2 Cable passage through the front wall of the cab
A similar cable passage in the front wall of the cab is located in
the area of the right (passenger) footwell (see Figure 9.6). This
is intended for front implement cables or cables which are
passed over the pivot point and therefore need not be taken
apart when the cab is being tilted (in particular with perma-
nently mounted implements / bodies).
For the exact position of the front cable passage, see vehicle
drawings on the Unimog Resource CD.
August 2005
Dimensions without brackets are in [mm].
Dimensions in brackets are in [in].
Figure 9.4: Cable passage through the rear wall of the cab
Figure 9.5: Cable passage through the front wall of the cab
Cab
Page 251 of
294