Table of Contents
Advertisement
Body and Implement Mounting Guidelines U500 North America
Dimensions without brackets are in [mm].
Dimensions in brackets are in [in].
Figure 4.65: Ball point, Part-No.: A405 991 00 20
August 2005
Two different ball half shells and locating bolts are available. Identi-
cal ball half shells must be mounted diagonally to avoid body or im-
plement damage (see Figure 4.66). Mounting the ball half shell in
diagonal manner will keep the operator from inserting the pins in the
wrong locations.
Figure 4.66: Diagonally mounting of the ball half shells
Four identical ball half shells can be used on bodies / implements
that do not tilt. Non-tilt able bodies / implements must always be se-
cured with four locating bolts! The shut-off valve of the tipping cylin-
der must be closed at vehicles equipped with tipping cylinder and
non-tilt able bodies or implements. These notes must be included in
the implement / body installation manual.
Warning:
Risk of vehicle and body / implement damage!
Improper use of locating bolts and shut-off valve
will cause damages to the implement / body and
the vehicle.
Implement / Body Installation
Page 115 of
294
Advertisement
Table of Contents
