REMKO MWL Series Operating And Installation Instructions page 30

REMKO MWL series
Now place the ventilation module on the fully low-
ered lift panel and push it into the unit as far as it
will go over the slide rails.
Fig. 28
Now push the unit to its target position by pressing
the lift panel back into its original position with both
thumbs (exclusively). The ventilation module is
thus guided into the ventilation connections by the
upward movement. Attention: The amount of force
required can be slightly increased by the leverage
and the rubber seals on the roof connection.
(We recommend filling the drinking water storage
tank beforehand and thus optimally shifting the
centre of gravity of the MWL so that the position of
the MWL is not accidentally changed when instal-
ling the modules. As soon as the target position is
reached, the lift panel noticeably engages.
Fig. 29
The MWL has now reached the status as shown in
figure Fig. 30.
30
Fig. 30
Now insert the electric module into the compart-
ment between the heat pump module and the ven-
tilation module.
Fig. 31
Push the electric module evenly into the unit as far
as it will go. Attention: We recommend carrying out
this procedure slowly and carefully so that the plug
connector on the back (which floats slightly) can
connect to the electrical module more easily and
without interference.
Fig. 32