Table of Contents
Advertisement
REMKO MWL series
4
Assembly
4.1 General installation notes
n
These instructions are to be observed when
installing the heat pump.
n
The unit should be delivered as near as pos-
sible to the site of installation in its original
packaging in order to avoid transport damage.
n
The unit is to be checked for visible signs of
transport damage. Possible faults are to be
reported immediately to the contractual partner
and the haulage company.
n
The indoor unit must be installed on a firm,
level surface.
n
The surface must possess sufficient load-
bearing capacity for the weight of the unit.
The height-adjustable feet can be used to level
n
the unit precisely
n
Suitable sites for installation are to be selected
with regard to machinery noise and the set-up
process.
n
Establish all electrical wiring in accordance
with the relevant DIN and VDE standards.
n
The electrical power cables must always be
fastened to the electrical terminals in the
proper manner. Otherwise there is a risk of fire.
n
Ensure that no pipes that carry water pass
through living or sleeping areas.
n
The unit is to be mounted in such a way that
there is sufficient space at the front for pur-
poses of installation and maintenance.
n
It is recommended to use a door with higher
sound insulation properties.
n
A floor drain or drain pan in the lower area of
the heat pump is recommended.
Fig. 11: Minimum distances
26
350
DANGER!
All electrical installation work must be done by
an electrician.
WARNING!
All electric lines are in accordance VDE regula-
tions to dimension and to lay.
WARNING!
Only fasteners suitable for the given application
may be used.
4.2 Assembly and installation
Setting up the heat pump
After pre-piping and laying the cables, set up the
frame at the desired location. Remove the cover
panel. The rear recess on the roof panel allows
convenient positioning under the pre-piping / wall
connections.
Fig. 12
Advertisement
Table of Contents
