To Remove And Replace The Usb Or Gpib Port - Keysight 90000 X Series Service Manual

Chapter 5: Replacing Assemblies

To remove and replace the USB or GPIB port

To remove and replace the USB or GPIB port
Use this procedure to remove and replace the USB or GPIB port (GPIB is an
option and may not be on your oscilloscope). The procedure is exactly the same
for both of these ports so only one will be shown here. When necessary, refer
to other removal procedures. The graphics in this chapter are representative of
the oscilloscope at the time of this printing. Your unit may look different.
Disconnect the power cable and remove the cover and top plate.
1
Remove the screw from top edge of chassis (Figure 5- 48).
2
Figure 5-48
Undo the connection to the motherboard by disconnecting the cable.
3
Pull the port out of the instrument.
4
To replace one of these ports, reverse the directions.
5
110