Quick Start; Safety And Installation; Location - ECD SmartDRY SD Series Setup And Operation Manual

8.0 QUICK START

The SmartDRY™ Cabinet is ready to plug in and begin using as soon as it is safely set up. The SmartDRY™ Cabi-
net is preset to meet the requirement of J-STD 033 for the safe storage of Moisture Sensitive Components. No
additional programming is required. Once unpacked, here are some steps to quickly get your SmartDRY™ Cabi-
net up and running.
Although pre-programmed to meet the requirement of J-STD 033, the SmartDRY™ cabinet must run for a mini-
mum of 8 hours to acclimate and regenerate its dryer module. Please allow this time before adding your mois-
ture sensitive components. Also, the alarm limits have been pre-programmed however, are not enabled. Once
the SmartDRY™ cabinet has stabilized at set point, the alarms can be enabled if desire. You may also want to
explore the other Alarms: SmartDRY™ Temperature, SmartBAKE™ RH, and SmartBAKE™ Temperature, ena-
bling them as you wish. Refer to section
WHEN ACCESSING OPTIONS THAT REQUIRE A PASSCODE THE SYSTEM DEFAULT PASSCODE IS 314.
AS YOU ENTER PROTECTED OPTIONS, YOU WILL BE PROMPTED TO ENTER IT USING THE UP OR
DOWN BUTTONS. ONCE SELECTED, ALL LOCKED OPTIONS REMAIN "UNLOCKED" UNTIL YOU RE-
TURN TO THE MAIN DISPLAY.
1) When prompted, Press and hold the Up or Down button to navigate to Passcode 314.
Press the OK button to be able to edit the protected field.

8.1 SAFETY AND INSTALLATION

Make sure you have read and follow the
the previous sections.

8.2 LOCATION

Move the SmartDRY™ Cabinet into the desired position. Refer to topic
SD Series Dry Cabinets Setup and Operation Manual | A55-7379-00 Rev: 2.0.0
9.1.2 Alarms (SmartDRY™)
4.0 Operators Safety Information
for detailed information.
and 5.0 Setup
5.2 Location for minimum distance.
recommendations in
Page 31