Operators Safety Information - ECD SmartDRY SD Series Setup And Operation Manual

4.0 OPERATORS SAFETY INFORMATION

The safety information in this section is for the benefit of operating personnel. Warnings and Cautions will also
be found throughout the manual where they apply.
The SmartDRY™ SD Series Dry Cabinets are ETL listed and self-declared to meet the requirements
of CE for the storage of components at low relative humidity and temperatures. It is not intended
for the storage of flammable, volatile or combustible materials. These units have been tested per
the requirements indicated in topic: Declaration of Conformity.
Hardware changes or modifications to the SmartDRY™ SD Series Dry Cabinets or components are not expressly
approved by ECD and could void the warranty.
THE WARRANTY WILL NOT COVER DAMAGE CAUSED BY NEGLECT OR ABUSE OF ANY ECD PROD-
UCTS. TO MAINTAIN THE SAFETY FEATURES INCORPORATED, OPERATION MUST BE IN STRICT
COMPLIANCE WITH THE REQUIREMENTS SPECIFIED HEREIN.
The SmartDRY™ SD Series Dry Cabinets and the recommended accessories have been designed and tested to
meet strict safety requirements. For continued safe operation, always follow these basic safety precautions:
•
Read this entire Setup and Operation Manual before using.
• Be sure you follow any city, county, or other ordinances in your area regarding the use of this cabinet.
•
Use only approved accessories.
•
Do not modify system components. Any alterations or modifications to your SmartDRY™ SD Series Dry Cabinets may be
dangerous and will void your warranty.
•
Always plug the cabinet power cord into a grounded electrical outlet that conforms to national and local electrical codes. If
the cabinet is not grounded, it can conduct electricity and may cause serious injury.
•
Do not connect the unit to a power source of any other voltage or frequency beyond the range stated in the power rating
on the cabinet's serial number plate.
• Do not modify the power cord provided with the unit.
•
Avoid damaging the power cord. Do not bend it excessively, step on it, place heavy objects on it. A damaged cord can eas-
ily become a shock or fire hazard. Never use a power cord after it has become damaged.
• Do not position the equipment in such a manner as to make it difficult to disconnect power cord.
•
Do not attempt to move the unit while in operation.
•
THIS IS NOT AN EXPLOSION PROOF CABINET. Do not place or use explosive, combustible, or flammable materials in the
cabinet.
•
Do not store liquids of any kind. Evaporation of any liquids, other than water, may damage the RH sensor.
• Disconnect the cabinet from the electrical power source before removal of any covers or panels.
•
Repairs or component replacements should be done by trained service personnel.
•
This cabinet is NOT suitable for use in Class I, II, or III locations as defined in the National Electric Code of the United States
of America, NFPA 70.
•
Do not block Cabinet Dryer units.
•
Do not touch Dryer unit vent area when in regeneration cycle.
SD Series Dry Cabinets Setup and Operation Manual | A55-7379-00 Rev: 2.0.0 Page 12