Advertisement
1
/ -20 x / "
5
4
8
hex washer bolt
1
/ -20 x / "
5
4
8
hex washer bolt
Figure 5
Figure 6
Instruct
Classroom Furniture - All Terrain
®
storage tower
(front, instructor-side)
"P"
marking
worksurface
Mobile Instructor's Desk
®
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Caster Installation
1. Locate the caster/hardware packet
that is shipped inside the storage
tower. Secure or remove any
loose components inside the
tower.
2. Carefully turn storage tower on
it's back-side on a soft, protective
surface. The tower may need to
be turned to different sides for
Assembly Instructions
part of the next assembly process.
Position the outriggers as
illustrated, with the "P" marking
face-up, over the appropriate
mounting holes at the underside
of the tower. Secure each
outrigger to the underside of the
tower with four
-20 x
" hex
/
/
1
5
4
8
washer bolts (Figure 5).
3. Thread the casters into the
outriggers. Locking casters
must be positioned to the front,
instructor-side of the storage
tower. Tighten the jamb-nut of
the caster to the outrigger with a
wrench (Figure 5).
4. Carefully raise the storage tower
to it's upright position on the
casters.
Worksurface Installation
1. Gently lay the worksurface
upside down on a soft, protective
surface. Position the mobile table
leg, as illustrated, over the
pre-drilled holes in the
worksurface and secure using
eight #14 x
" black screws.
/
7
8
Thread the casters into the
mobile table legs and tighten the
jamb-nut of the caster to the leg
with a wrench (Figure 6).
2. Orient the modesty beam over
the worksurface as it will mount
to the worksurface. Snap spacers
into modesty beam holes so that
the spacers are in between the
modesty beam and worksurface.
Place the modesty beam onto the
worksurface over the pre-drilled
holes making sure spacers are
lined up. Secure the horizontal
mounting flange to the underside
of the worksurface with two
#14 x
/
" screws. Next, align the
7
8
mounting holes in the vertical
mounting flange of the modesty
beam to the vertical tube of the
table leg. Using a screw driver
and #2 Phillips bit, secure
modesty beam to table leg using
two #10-16 x
/
" screws
1
2
(Figure 6).
3
Advertisement
