Advertisement
Extol
Auditorium Seating
™
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Upright Installation
1. Per the space-planning layout,
stage uprights to appropriate
locations on the floor.
Note: Each row will consist of
right- and left-end uprights, with
shared uprights in between.
2. Align the mounting holes in the
upright with the site appropriate
and properly installed floor
anchors. Insert site appropriate
fasteners with flat washers
through to the floor. Do not
tighten uprights to the floor
at this time. Leave head of
fastener approximately
/
" loose
1
16
from contacting the upright
(Figure 1).
Back Attachment
1. Per the space-planning layout,
stage back assemblies by size to
appropriate upright locations on
the floor.
Note: Left- and right-end
uprights (right-end shown) have
a set of weld-nuts attached to the
uprights for attaching the back
assembly with M6 x 6mm cap
screws. Shared uprights use M6
nuts and M6 x 6mm cap screws
to secure the back assemblies at
the top and bottom.
2. Starting at either end of the row,
loosely twist in a M6 x 6mm cap
screw into the bottom rear hole
in the end-upright back bracket.
Then insert a M6 x 6mm cap
screw through the bottom rear
hole in the shared upright and
loosely twist on a M6 nut
(Figure 2).
3. Lift up and position the back
assembly in between the two
uprights until the appropriate two
slots in the lower part of the back
brackets nest onto the two loosely
attached M6 x 6mm cap screws
in the upright's back bracket
(Figure 2).
4
Advertisement
