Table of Contents
Advertisement
short or full-height
modesty panel
keyhole
clip slot
end
panel
shoulder
leg
screw
Detail C
end panel
short or full-height
leg
modesty panel
keyhole
clip slot
shoulder
screw
Detail D
end panel
short or full-height
leg
modesty panel
shoulder
keyhole
screw
clip slot
Detail E
weighted
rubber
mallet
short or
full-height
end panel
modesty panel
leg
Detail F
short
modesty
panel
mounting
bracket
Figure 5
mounting
bracket
full-height
modesty panel
Figure 6
short
modesty
panel
short
modesty
panel end
Detail G
Serenade™ Gathering Table - 18-24" Deep Tables
keyhole
clip
shoulder
end panel
screw
leg
shoulder
screw
keyhole
clip
end panel
leg
end panel
leg
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
18-24" Deep Tables - Modesty
Panel Installation
Note: A wide range of table
dimensions are available for Serenade
Gathering tables. The figures and
details on this page illustrate
short and full-height modesty panel
installation for a 24 x 60" table. Your
configuration may vary.
1. With the assistance of a second
person, have one person hold one
end panel leg securely in the upright
position, while the second person
follows step 2 below (Figures 5 & 6).
2. Orient the modesty panel as illustrated,
so the overhang of the installed
mounting brackets face the front,
"user side" of the table (Figures 5 & 6).
3. Position the end of the modesty
panel toward the shoulder screws
installed in the end leg, aligning
them so the larger openings of all
keyhole clip slots align to the screw
heads of the shoulder screws
(Detail C). Press the modesty panel
to the end panel leg, capturing screw
heads in the clip openings (Detail D).
4. Holding the modesty panel square
to the end leg, press down on the
modesty panel at the location of the
shoulder screws to help seat the
screw heads in the keyhole clips
(Detail E). Use a weighted rubber
mallet to tap carefully on the modesty
panel and completely seat the panel
top to be flush with the top of the end
panel leg (Detail F).
Note: If a full-height modesty panel
was installed securely to the end
panel leg, the table assembly is
stable enough to support itself in the
upright position. If a modesty panel
was installed securely to the end
panel leg, the modesty panel end
may be placed on a soft, protective
surface to support the table assembly
as illustrated in Detail G.
5. If the Serenade Gathering Table being
assembled is 60-96" wide, proceed
to "60-96" Wide Stringer Installation"
instructions on page 8. If the table
being assembled is 108-144" wide,
proceed to "108-144" Wide Stringer
Installation" instructions on page 9.
7
Advertisement
Table of Contents
