Nesting Leg Installation - KI Pirouette Assembly Instructions Manual

Pirouette Tables - Nesting-Base
®
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.

Nesting Leg Installation

1. Place tabletop upside down on a
soft, protective surface. Position
the nesting table support beam
assembly onto the center of the
tabletop underside, making sure
that the tabletop lock paddles
on the support beam assembly
face the user side. Slide a table
support end cap into position at each
of the four locations on the support
beam and align the mounting holes in
the caps with the pre-drilled holes in
the table. Use a cordless drill with
a #3 Phillips bit to secure end caps
and table support to underside
of worksurface using two
M5.5 x 42.2 mm Phillips flat head
wood screws at each cap location
(Figure 1 & Detail A).
4
M5.5 x 42.2 mm Phillips
at head wood screw
nesting table
support beam
assembly
tabletop
lock paddle
(face user side)
Figure 1
nesting leg
(right)
tabletop lock paddle
(face user side)
Detail A
table
support
end cap
tabletop
tabletop