Advertisement
Napoli Installation Guide - Surface Profiles
Using suction glass lifters, lift the glass In Line panels into the vertical wall profiles and gently
5
lower them into the Underframe channel. The Underframe Insert is supplied cut to the correct
length, which is equal to the width of the glass Door plus 8 mm clearance for vertical seals.
Position the In Line panels so that the Underframe Insert fits snugly between them.
Use a spirit level to ensure that the edge of each panel is plumb vertical. If necessary, insert
additional rubber strips under the panel (a maximum of 3 thicknesses) to achieve this and
note the position of the rubber.
The Majestic Shower Company Limited
17 Flitch Industrial Estate, Chelmsford Road, Dunmow, CM6 1XJ
Mark the positions of the edges of the In Line panels with tape on the underframe so
6
that they can be removed and replaced in the same position.
Mark the vertical wall profiles at the top edge of the glass for trimming if they are
too long.
Telephone +44 (0) 8448 001 500
Facsimile +44 (0) 1279 635 074 info@majesticshowers.com www.majesticshowers.com
5
Advertisement
