Advertisement
Napoli Installation Guide - Surface Profiles
12.5mm
One Glass to Glass vertical sea is to be pushed on to the edge of the In Line panel on the
17
handle side of the Door, touching the underframe and trimmed level with the glass at the top.
The second vertical seal is to be cut in 3 sections to fit to the edge of the In Line panel above,
below and between the hinges.
For maximum resistance to leakage, the seal sections should be cut as shown above to allow
them to fill the gaps in the hinge through which water might otherwise escape.
The Majestic Shower Company Limited
17 Flitch Industrial Estate, Chelmsford Road, Dunmow, CM6 1XJ
Slit here
PANEL SIDE
Notch
Notch
Open the door and slide the 3 sections of seal on to the edge of the glass panel,
18
pushing the notched ends inside the hinge as shown.
The lower section of the seal should be cut straight and pushed down to touch
the Underframe (see illustration at Step 19).
.
Telephone +44 (0) 8448 001 500
Facsimile +44 (0) 1279 635 074 info@majesticshowers.com www.majesticshowers.com
11
DOOR SIDE
Slit
VIEW FROM
INSIDE OF
(OUTWARD
OPENING
DOOR)
GLASS NOT
SHOWN
Slit
Advertisement
