Advertisement
Napoli Installation Guide - Surface Profiles
IN LINE PANEL
Rubber
packing
strips
Hinge with face
plates removed
for illustration
purposes only.
Insert short pieces of the self adhesive rubber strip supplied in each In Line panel hinge slot
13
as shown to ensure that the door does not drop under its own weight over time.
Disassemble the hinges, being careful not to damage the polished surfaces, and place the
hinges and their face plates either side of the hinge slots on the In Line panel with screws
facing inwards. Ensure that each face of the glass is separated from the hinges by a gasket.
Loosely screw the hinges and face plates together.
The Majestic Shower Company Limited
17 Flitch Industrial Estate, Chelmsford Road, Dunmow, CM6 1XJ
DOOR
Rubber
strips
Position the hinges centrally in their slots and use a set square to align them with
14
the edge of the glass. Check that the holes are adequately packed with the rubber
strips by using a set square to ensure that the hinges are at 90 degrees to the
edge of the glass when upward pressure is applied to them.
Fully tighten the hinge screws on the In Line panel to 10-12 NM torque.
.
Facsimile +44 (0) 1279 635 074 info@majesticshowers.com www.majesticshowers.com
Telephone +44 (0) 8448 001 500
9
Advertisement
