Table of Contents
Advertisement
3.1.7 Servo installation
Figure 3.1.23 Shematic diagram of servo installation
Figure 3.1.24 Effect diagram of servo installation
In order to reduce the angle adjustment of the servo, we need to adjust the servo to 90 degrees.
First, we should (Lesson\ModuleDemo\ServoTest\ServoTest.ino) Download it to the control panel, and the
three wires of the steering gear are the signal wire (orange), power wire (red), and ground wire (brown), and
then connect the signal wire of the steering gear (orange) to port 13 of Arduino, and install the rudder
propeller without fixing screws, as shown in figure 3.1.7.1.
24
Advertisement
Table of Contents
