Table of Contents
Advertisement
3.1.7 Servo installation
Figure 3.1.27 Shematic diagram of servo installation
Figure 3.1.28 Effect diagram of servo installation
In order to reduce the angle adjustment of the servo, we need to adjust the servo to 90 degrees.
First, we should copy the following program (Lesson\ModuleDemo\Servo\ServoCorrect\ ServoCorrect.ino)
into the compilation environment. Then, we need to make the signal line of servo(orange) be connected to
port 13 of Arduino board. Finally, we need to fix rudder wing by screws, and fix the ultrasonic bracket on
the rudder wing.
25
Advertisement
Table of Contents
Need help?
Do you have a question about the Hummer-Bot-1.0 and is the answer not in the manual?
Questions and answers