Keywish Hummer-Bot-2.0 Instruction Manual page 103

3、Lead the wire according to the hole marked "1" in Figure 3.2.57, and connect the wire to the Aruino
expansion board with reference to Figure 2.3.58. After the completion, as shown as Figure 2.3.57.
Figure 3.2.57 Wire Connection Diagram
Figure 3.2.58 Connection of Arduino and Receiving Head Wires
"Lesson\ModuleDemo\PS2X\PS2X.ino"
4、Open
Finally, download the program to the Arduino development board and turn on the PS2 remote control. If the
receiver head is connected to the remote controller (or the pairing is successful), the indicator light on the
receiver head is long, and the LED light is blinking. Finally, we open the "serial monitor", press any button
100