Replacing The Array Or Expansion Module Chassis; Figure 136 Dxi6900 G1 Array Module Or Expansion Module Chassis - Quantum DXi6900 Field Service Manual

Figure 136 DXi6900 G1 Array
Module or Expansion Module
Chassis
Replacing the Array or
Expansion Module
Chassis
Quantum DXi6900 G1 User's Guide
Illustration
This section describes how to remove and replace the DXi6900 G1 Array
module (RBOD) or Expansion module (EBOD) chassis. There are several
items within the Array module or Expansion module chassis that are not
replaceable as individual FRUs. If any of these components fail, the
entire Array module or Expansion module chassis must be replaced.
Caution: Use appropriate ESD precautions, including the use of a
grounding strap, when performing this procedure.
Removing and replacing the DXi6900 G1 Array module or Expansion
module chassis includes the following steps:
• Removing a Failed Array or Expansion Module Chassis
• Installing a Replacement Array or Expansion Module Chassis
Removing a Failed Array or Expansion Module Chassis
To remove the DXi6900 G1 Array module or Expansion module chassis:
1 Shut down the system (see
System on page 23).
2 Remove all power and SAS cables from the rear of the Array module
or Expansion module. Make sure to label the cables so they can be
easily identified when they are re-connected to the Array module or
Expansion module after the replacement procedure is complete.
Chapter 3: FRU Removal and Replacement Procedures
Replacing an Array or Expansion Module
Turning On and Shutting Down the
Description
Replacement Array
module (RBOD) or
Expansion module
(EBOD) chassis
PN 9-02383-01
209