Replacing The Node Integrated Storage Controller; Obtaining A Replacement Integrated Storage Controller - Quantum DXi6900 Field Service Manual

Chapter 3: FRU Removal and Replacement Procedures

Replacing the Node Integrated Storage Controller

Replacing the Node Integrated Storage Controller
Obtaining a
Replacement
Integrated Storage
Controller
124
Note: To install a full length card, use the supports provided on
the cooling shroud.
4 If applicable, connect any cables to the expansion card.
5 Install the expansion card riser (see
6 Close the Node cover (see
7 Turn on the system (see
on page 23).
8 Run Factory Detect Hardware from the Service Menu to detect the
new hardware (see
9 In the remote management console, delete any administrative alerts
and close any service tickets.
This section describes how to remove and replace the integrated storage
controller in the DXi6900 G1 Node and contains the following sections:
•

Obtaining a Replacement Integrated Storage Controller

• Replacing the Integrated Storage Controller
Before beginning the replacement procedure, make sure that you have
the required replacement kit. The appropriate replacement integrated
storage controller will be provided by Quantum Customer Support (see
Figure 73).
You will need the following items to perform this procedure:
• Replacement integrated storage controller kit provided by Quantum
Customer Support.
• ESD grounding wrist strap (included in the replacement kit)
Figure 70
Opening and Closing the
Turning On and Shutting Down the System
Factory Detect Hardware
Quantum DXi6900 G1 User's Guide
and Figure 71).
Node).
on page 44).