Getting Started; Overview - ST X-NUCLEO-OUT13A1 User Manual

1

Getting started

1.1

Overview

The X-NUCLEO-OUT13A1
overcurrent and overtemperature protection for safe output loads control.
The board is designed to meet the application requirements for the galvanic isolation between the user and power
interfaces.
The galvanic isolation embedded by the
optocouplers, with a consequent cost saving and a reduced application size.
The expansion board features:
• Based on the
– Operating range 9.2 to 36 V
– Low power dissipation (R
– Process side operating current: up to 1 A per channel
– Embedded 2 kV
– Direct (jitter < 20us) and synchronous (jitter < 6us) control modes
– Fast decay for inductive loads
– Undervoltage lock-out
– Overload and overtemperature protections
– Loss of ground protection
– PowerSO36 package
• Application board process side operating range: 10 (J10 open) to 33 V (J9 closed)
• Extended operating range of process side from 9.2 (J10 closed) up to 36 V (J9 open)
• Application board logic side operating voltage 3.3 to 5 V
• Green LEDs for outputs on/off status (J6 and J7 close 1-2, 3-4, 5-6, 7-8)
• Red LED for common overheating and communication error diagnostic (J3 close 1-2)
• Yellow LED for output enable status signalization (J3 close 5-6)
• Direct control mode (J1, J2 closed)
• Synchronous control mode (J1, J2 open)
• Process and logic supply rails reverse polarity protections
• Compatible with
• Equipped with Arduino
• RoHS and China RoHS compliant
• CE certified
• Radiated emission: class B according to the standard EN 55032
UM3081 - Rev 1
embeds the ISO808-1
ISO808-1
ISO808-1 octal high-side switch, which features:
= 260 mΩ)
ON(MAX)
galvanic isolation
RMS
STM32 Nucleo development boards
®
UNO R3 connectors
intelligent power switch (IPS), which features galvanic isolation,
satisfies this requirement, avoiding the necessity of external
UM3081
Getting started
page 2/19