Table of Contents
Advertisement
1.6
Board setup
Step 1.
Connect the mini-USB or micro-USB cable to your PC to use the
F401RE
Step 2.
Download the firmware (.bin) onto the
STM32 ST-LINK
the table below.
The
J1 and J2 open (synchronous) or J1 and J2 closed (direct).
The binary files provided with the
synchronous control mode. The user can anyway set the preferred control mode by using the
preprocessor directive USE_SCM (for synchronous) or USE_DCM (for direct). The modification to
control mode becomes effective on the binary files after rebuilding.
EWARM-OUT11_13-
STM32F4xx_Nucleo.bin
EWARM-OUT11_13-
STM32G4xx_Nucleo.bin
Step 3.
Connect the
Step 4.
Provide the digital supply voltage (see
Step 5.
Connect the load on the output connector (see
Step 6.
Reset the example sequence by pushing the black button on the
Step 7.
Push the blue button on the
default firmware package.
UM3081 - Rev 1
or
NUCLEO-G431RB
development board
utility, STM32CubeProgrammer, and according to your IDE environment as detailed in
X-NUCLEO-OUT13A1
must be configured coherently to the selected control mode for ISO808-1:
Table 1.
NUCLEO-F401RE development board supported IDEs - bin files
IAR
MDK-ARM-OUT11_13-
STM32F4xx_Nucleo.bin
Table 2.
NUCLEO-G431RB development board supported IDEs - bin files
IAR
MDK-ARM-OUT11_13-
STM32G4xx_Nucleo.bin
ISO808-1
device supply voltage via CN1 (see
STM32 Nucleo
STM32 Nucleo
development board microcontroller through
X-CUBE-IPS
software package are generated by enabling the
NUCLEO-F401RE
Keil
NUCLEO-G431RB
Keil
Section 1.3 Power
Section 1.2 Digital
section).
Section 1.3 Power
board to choose among the examples provided in the
UM3081
Board setup
X-NUCLEO-OUT13A1
with
NUCLEO-
STM32CubeIDE
STM32CubeIDE-OUT11_13-
STM32F4xx_Nucleo.bin
STM32CubeIDE
STM32CubeIDE-OUT11_13-
STM32G4xx_Nucleo.bin
section).
section).
STM32 Nucleo
board.
page 6/19
Advertisement
Table of Contents
Need help?
Do you have a question about the X-NUCLEO-OUT13A1 and is the answer not in the manual?
Questions and answers