Hardware Requirements; System Requirements; Figure 4. X-Nucleo-Out13A1 And Stm32 Nucleo Stack - ST X-NUCLEO-OUT13A1 User Manual

1.4

Hardware requirements

The X-NUCLEO-OUT13A1
G431RB STM32 Nucleo development boards.
To function correctly, the
pins on the STM32 Nucleo
1.5

System requirements

To use the STM32 Nucleo
• a Windows PC/laptop (Windows 7 or above)
• a type A to mini-B USB cable to connect the
F401RE
• a type A to micro-B USB cable to connect the
G431RB
• the X-CUBE-IPS
UM3081 - Rev 1
expansion board is designed to be used with the
X-NUCLEO-OUT13A1
board as shown below.
Figure 4. X-NUCLEO-OUT13A1 and STM32 Nucleo stack
development boards with the
development board
development board
firmware and software package installed on your PC/laptop
must be plugged onto the matching Arduino
X-NUCLEO-OUT13A1
STM32 Nucleo board to the PC when using a
STM32 Nucleo board to the PC when using a
UM3081
Hardware requirements
NUCLEO-F401RE or NUCLEO-
®
UNO R3 connector
expansion board, you need:
NUCLEO-
NUCLEO-
page 5/19