8-1.2 Repair; 8-1.3 Installation - Big Joe E30 Operation, Maintenance And Parts Manual

8-1.2. Repair
1. Remove pins (11,
load wheel (13) from wheel brackets (8).
2. Remove pins (11) and shafts (10). Free brackets
(8) from tension bars (6).
3. Remove bushings (9) from brackets (8) if replace-
ment is necessary,
4. Remove clips (2) from link (1) and free tension
bars from link (1).
5. Loosen nuts (4) and remove clevises (5) from ten-
sion bars (6).
6. Remove bushings (3) from clevises (5) if replace-
ment is necessary.
7. Install reassemble by reversing the steps above.
R6745
8-2
Figure 8-2), shafts (12) and
Figure 8-2 Lift Linkage Assembly
8-1.3. Installation
1. Position link assembly under frame (8,
1).
2. Raise each link assembly (14,
position and install shaft (9,
frame (8). Secure shaft (9) with clips (3).
3. Position wheel brackets (8,
(8, Figure 8-1) and install shafts (6). Secure shafts
(6) with pins (7).
4. Position link assembly (14) and install shafts (10).
Secure shafts (10) with pins (11),
5. Remove blocking and lower the truck to the
ground.
6. Turn on the key switch (20,
emergency disconnect (17).
Figure 8-
Figure 8-2) into
Figure 8-1) through
Figure 8-2) in frame
Figure 12-18) and
BL-E30-0515 - 07-27-2016