Big Joe E30 Operation, Maintenance And Parts Manual page 33

Parameter
EMERGENCY
REVERSE MENU
Speed (90A Only)
Time Limit (90A Only)
Decel Rate (90A Only)
Accel Rate (90A Only)
Max Braking Current
(90A Only)
Switch Normally
CLosed (90A Only)
MISCELLANEOUS MENU
Sleep
Fault Code Type
Reset Drive Time
Emergency Stop
(90A Only)
BL-E30-0515 - 03-01-2018
Table 4-2 Programmable Parameters - Continued
Factory Setting
70A 90A
Defines the maximum reverse speed of the motor when emer-
N/A 30%
Defines how long emergency reverse is allowed to be active
N/A 3 sec.
Sets the rate at which the vehicle brakes to a stop when eme-
N/A 0.6 sec.
Sets the rate at which the vehicle sccelerates in the reverse
N/A 1.5 sec.
Defines the maximum allowed motor current when the vehicle
N/A 90A
Defines the emergency reverse switch (belly button switch)
N/A OFF
On = BB switch is normally closed when it is not pressed.
Off = BB switch is normally open when it is not pressed.
Sets the delay time between the last throttle request or serial
0 0
This parameter selects which set of fault identification codes
2 0
The controller's hourmeter logs the total drive time since the
OFF
N/A
Defines how the vehicle will respond when the emergency stop
On =The EM brake will be engaged rapidly when the emer-
N/A ON
Off =When the emergency stop button is pressed, the battery
Description
gency reverse is active.
after the vehicle is moving in reverse direction. Setting this
parameter to zero means there is no time limit.
gency reverse is activated and the vehicle is moving forward.
If the vehicle is already moving in the reverse direction above
the programmed EMR speed, it will be brought down to the
EMR speed.
direction when emergency reverse is activated. speed.
brakes to a stop when emergency reverse is activated.
type.
communication and when the controller goes into sleep
mode. Setting the delay to zero disables the sleep function
(Type 0,1, or 2) will be flashed by the status LED.
last reset; this record is accessible through the Monitor
menu. Setting this parameter ON zeroes the hourmeter and
starts a new log; this is typically done when the vehicle is ser-
viced. Reset Drive Time is automatically set to Off after the
hourmeter is reset.
button is pressed.
gency stop button is pressed; the battery is disconnected and
the vehicle will stop abruptly.
is disconnected and the vehicle will decelerate for a short dis-
tance before it fully stops.
4-15