Big Joe E30 Operation, Maintenance And Parts Manual page 32

Parameter
BDI MENU - Cont.
Start Charger
Voltage
Reset Voltage
Discharge Factor
Charge Factor
Low BDI Level
Low BDI Max Speed
COMPENSATION MENU
IR Comp
Anti-Rollback Comp
4-14
Table 4-2 Programmable Parameters - Continued
Factory Setting
70A 90A
Voltage above which the battery is considered to start
25.2V 25.2V
Note: Allowable range is restricted by the Full Voltage and Full
Voltage at which the BDI calculator will be reset to 100%, after
25.0V 25.0V
Note: Allowable range is restricted by the Full Voltage setting.
Discharge rate of the battery. Larger values are for larger bat-
2.0 2.0
Charge rate of the battery. Larger values are for larger batter-
2.0 2.0
Sets the battery charge level at which maximum vehicle speed
44% 40%
Sets the maximum allowed vehicle speed when the battery
15% 15%
Sets the motor load compensation. Higher values provide
70% 70%
Note: Allowable range is restricted by the Anti-Rollback Comp
Sets the motor load compensation after the throttle is released
90% 90%
Note: Allowable range is restricted by the IR Comp setting.
Description
charging.
Charge Voltage settings.
the charger is disconnected and the controller is powered up.
teries, which discharge more slowly.
ies, which charge more slowly.
will be limited in order to protect the battery from deep dis-
charge. Setting Low BDI Level to zero disables this function
and allows the battery to discharge completely.
charge falls below the programmed Low BDI Level.
stronger disturbance rejection, while lower values provide
smoother operation.
setting.
to neutral and the speed is estimated to be near zero. Higher
values provide more hill-holding force.
BL-E30-0515 - 03-01-2018