Steering Arm; 5-4.1 Return Spring Replacement; 5-4.2 Steering Arm Removal; 5-4.3 Steering Arm Installation - Big Joe E30 Operation, Maintenance And Parts Manual

5-4. STEERING ARM

5-4.1. Return Spring Replacement.
The steering arm gas return spring (8,
replaced while the steering arm (13) is in the upright
position.
1. Secure the steering arm (13) in the upright posi-
tion.
2. Remove screw (1) and free the gas return spring
(8) from bracket (5).
3. Pull downward on the gas return spring (8) to free
it from its seat inside steering arm (13).
4. Position the new gas return spring (8) inside the
steering arm being sure it fully engages its seat.
5. Position the opposite end of the gas return spring
(8) on bracket (5) and install screw (1).
5-8
5-4.2. Steering Arm Removal.
1.
Figure 5-1) is
2.
3.
4.
5-4.3. Steering Arm Installation.
1.
2.
3.
Remove steering arm gas return spring as
described in paragraph
Disconnect harness (15,
(3, Figure 12-20 or Figure
Attach a hoist to steering arm (13,
Remove shaft (9) and the steering arm (13).
Position steering arm (13,
bracket (5) and secure with shaft (9).
Reconnect harness (15,
Figure 12-20 or Figure 12-21).
Install steering arm gas return spring as described
in paragraph 5-4.1.
BL-E30-0515 - 03-01-2018
5-4.1.
Figure 5-1) from harness
12-21).
Figure 5-1).
Figure 5-1) over
Figure 5-1) to harness (3,